Taking down and packing up the tripod

Lowering the mast

1. Hold the extended section of the mast firmly and loosen the knob at the bottom of this section
2. Lower the mast calmly until that section has disappeared completely into the tripod
3. Tighten the knob firmly again
4. Repeat this for each extended section, until the whole mast is retracted
5. Did you extend a leg for a slope? Hold the tripod, loosen the knob on the leg, let the leg slide in carefully and tighten the knob again

Removing the camera

6. Check in the USF.Go app that the recording has stopped. The green light on the camera will then no longer flash
7. Switch off the camera: press and hold the power button for about 5 seconds
8. Press down the tab at the back of the mount and turn the lever over the tab
9. Lift the camera calmly out of the mount, release the lever and put the camera in the case
10. Unscrew the black mount from the tripod and put it in the case. The gold adapter can stay on

Folding the tripod

11. Hold the mast and loosen the two lowest knobs
12. At the upper of these two knobs, take hold of the part that connects the legs, pull it up as far as it will go and tighten that knob
13. Push the lower, still loose knob towards the ground until the legs are almost completely folded in
14. Push each leg the last bit against the tripod and tighten the lowest knob

Did you record without a livestream? Then you still need to upload the recording: see Uploading a USF.Go recording to the dashboard.